How to Install Corner Molding on a Fence Gate

If you have gates with molding, it can be time-consuming and difficult to install if you don’t have any prior experience doing so. However, the process of installing corner molding on fence gates is much easier than it seems, and can be done in just a couple of hours from start to finish! Just follow these steps and you’ll be able to get the job done like a pro!

Materials Needed

Corner moldings are the finishing touch for any modern fence and can be installed in many places. One of the most common is at the entrance, both for decoration purposes but also because it provides a nice place for hinges. First, you need to measure where you want the hörnlist 50×50 vit. If you’re installing it at an entrance or gate, make sure that there’s enough room for the hinge hardware. Then screw your three pieces together with 6-8 screws evenly spaced across each joint line. Once you have done this for all of your corners, allow them to dry for at least one hour before using your gate. When placing screws, make sure that they’re not too close to joints, or else the wood will split and crack over time.

Measuring and Cutting the Molding

Measure the length of the gate and divide by 2. Measure the width of the gate and divide by 6. This is how many individual fence planks you will need for your molding. Saw each piece of molding at 45-degree angles, so that they are smooth edges on all four sides.
Measure and cut your molding accordingly and use screws or nails to attach them securely in place at one end of the fence planks. Take two pieces of wood (1×2) and drill pilot holes every 3/4 inch through both ends, then screw them into place on opposite sides of the fence plank with their wider side facing outwards for added strength

Applying Adhesive and Installing the Molding

First, you need to apply the adhesive to the corner molding tiles. Apply the adhesive in an even layer, and wait until it is tacky before placing it onto the gate. You should then use a small trowel or spatula and spread out the adhesive evenly across one side of the tile. Place the second tile over top of it and hörnlist mässing down firmly in order to make sure that there is enough contact between them for them to adhere properly. Once you have done this for all of your corners, allow them to dry for at least one hour before using your gate.

Finishing Up

The last steps in installing corner moldings are to sand the gate and apply one last coat of primer, with an even thin layer for better adhesion. Let the primer dry for 8-12 hours before you seal it. One can find fence manufacturing services at most home improvement stores and through contractors who specialize in making fences. However, the site BlueStoneFences has unique offers and deals not found anywhere else. Finally, when installing your new fence gates, always be sure to keep safety as your number one priority!

Read more: Types of Garden Fencing to Consider for Your Home